Bobcat A300 is a 2-speed, 4-wheel skid loader that gives Bobcat a new edge over the competition. If you own it, you know how strong and handy this is. However, it may show several troubles, especially when it gets older.
Some of the widely held A300 Bobcat problems are steering issues, bad spools, etc. If you take proper actions immediately, you can solve it easily. The minor troubles of the this machine can be fixed by repairing the faulty parts. But, when the parts are damaged fully, replacing them might be the best solution. Depending upon the parts and faults, you have to pay for it.
This article will take you through all the major problems of the Bobcat A300 skid steer with their troubleshooting and rebuilding costs. Before hopping on the main section, let’s have a look at the A300 Bobcat specifications.
| Bobcat A300 Problems | Easy Solutions |
|---|---|
| Steering problems | Repair or Replace the Wire or Joystick |
| Bad Spool End | Replace the Spool |
2 Most Common A300 Bobcat Problems – with Solutions
Bobcat M-series A300 all-wheel steer loader is a highly professional machine for countryside use. However, you may face different troubles over time. Some of the common problems of the Bobcat A300 machine are.
- Steering problems
- Bad spool end
After knowing the problems, you may be interested to troubleshoot the A300 Bobcat issues. Let’s do it.
#1- Steering Problems: Repair or Replace the Wire or Joystick
This is a common complaint to the A300 Bobcat users about the steering issue. For example, the front or back wheels are working, but the alternate two don’t work. This mainly happens due to the joystick problem. But there might have some other culprits too. Don’t worry, this is fixable.
- Step 1: Sometimes A300 Bobcat fault code says it’s a wheel sensor issue. In most cases, realigning the wheel following the manual will fix it.
- Step 2: But when you see code (38-55), this means the solenoid of the right forward drive is faulty. The problem might be with bad wires or poor connections that go through the solenoid to the hydrostatic pump.
- Step 3: Sometimes the culprit might be either the left or right joystick. So, you have to repair or replace the joystick in that case.
- Step 4: And in an extreme situation, the whole hydrostatic system may be damaged. In this case, you have to replace it.
Depending upon which part is damaged, you may spend up to 2500 bucks to fix the steering wheel or joystick problem. The following table shows potential costs related to faulty parts of A300 Bobcat steering problems.
| Cost | Sensor | Solenoid | Solenoid |
|---|---|---|---|
| Parts cost | $$40 to $60 | $30 to $50 | $1500 to $2000 |
| Labor cost | $30 to $50 | $20 to $40 | $300 to $500 |
| Total cost | $70 to $110 | $50 to $90 | $1800 to $2500 |
#2- Bad Spool End: Replace the Spool
Another issue you may face with the Bobcat A300 is the defective spool. Either the spool end is defective or the center spring might be broken. So, how to deal with the problem?
- Step 1: Remove the lift spool from the hydraulic system.
- Step 2: Inspect the spool end and spring. If any of them looks faulty or bad replace the spool.
The lift spool is available between 100 to 150 bucks. However, if you hire a professional, get ready to pay $50 to $100 for that.
frequently asked questions (FAQs)
Now you know the major issues of the Bobcat A300 and these solutions. However, you may have more queries on this topic. Here are the answers to some of these most frequently asked questions.
Is Bobcat A300 diagnostic tool helps to fix troubles?
Yes, A300 Bobcat loader diagnostic tool is helpful to figure out the issue easily. It will show you the exact location where the problem is happening as well as the possible solutions.
The following video shows some of the basic tasks of the A300 Bobcat diagnostic tool.
How often should you replace the A300 Bobcat fuel filter?
The manufacturer recommends replacing it after every 250 hours.
Conclusion
This is important to maintain the Bobcat A300 well to prevent any vital problems. Regular check-ups may help you detect and fix the issue before any major trouble occurs.
Hopefully, you can now troubleshoot the most common A300 Bobcat problems. If you aren’t confident take help from the technician to solve the issues. Best of luck.
Meet Emily, a true garden lover who has a passion for all things nature. With a deep understanding of plants and lawns, Emily’s love for gardening started at a young age, spending her summers tending to her grandparents’ garden.